ఒక అధ్బుతమైన సామర్ధ్యం యొక్క ఒక యూనిట్,

microfarads's Usage Examples:

022 microfarads was used for the tone circuit.

Examples of short-marking of the rated capacitance (microfarads): µ47 0,47 µF, 4µ7 4,7 µF, 47µ 47 µF The date of manufacture is.

high-voltage capacitors for the valve amplifier technique, typically at least 4 microfarads and rated at around 500 volts DC.

Examples of short-marking of the rated capacitance (microfarads): µ47 0.

Values of capacitors are usually specified in farads (F), microfarads.

squared; photoflash capacitors have capacitance in the range 80-160 microfarads (μF) and voltages from 180–330 volts for flash units built into small.

The capacitors" values are two microfarads for the exit of the line toward Czech Republic and one microfarad for.

come in a variety of sizes, depending on the capacitance (measured in microfarads, µF), such as 40 plus 5 µF, and also on the voltage.

Values of capacitors are usually specified in farads (F), microfarads (μF), nanofarads (nF) and picofarads (pF).

DVMs can usually measure capacitance from nanofarads to a few hundred microfarads, but wider ranges are not unusual.

The capacitors" values are two microfarads for the exit of the line toward Czech Republic and one microfarad for the exit toward Austria.

2 microfarads at 1000 volts), into the coil via a trigatron or a thyratron switch.

supply capacitors required for an OTL design (at least thousands of microfarads at 200 volts or better).