(ਇਲੈਕਟ੍ਰੋਨਿਕਸ,

Noun:

ਡੀਮੋਡੂਲੇਸ਼ਨ,

demodulation's Usage Examples:

present and allow synchronizing the phase of the local oscillator in the demodulation circuitry.

Usually sine and cosine demodulation is performed simultaneously, which is sometimes also referred to as dual-phase demodulation.

A demodulator (sometimes detector) is a circuit that performs demodulation, the inverse of modulation.

At the receiving station, the message signal is extracted from the modulated carrier by demodulation.

Modern vector network analyzers measure amplitude and phase of voltage traveling wave phasors using essentially the same circuit as that used for the demodulation of digitally modulated wireless signals.

as shifted to the intermediate frequency) from a greatly reduced "pilot" carrier (in reduced-carrier transmission or DSB-RC) to use in the demodulation.

The passband modulation and corresponding demodulation (also known as detection).

wave and the receiver"s local oscillator for the purpose of coherent demodulation.

This comes at the expense of demodulation complexity.

The result is a reversed-phase sideband on +1 MHz; on demodulation, this results in unwanted output at 6 – 1 5 MHz.

intervals separating any two significant instants of modulation (or demodulation), to the unit interval.

Both commercial and free software for demodulating HRPT transmission signals exists: Example of commercial demodulation.

However, a slightly more complex demodulation compensates for that simplicity on the VPPM technique.