रिक्रिस्टलाइजेशन इसके अंग्रेजी अर्थ का उदाहरण

The shear forces cause deformation and recrystallization that drive the movement, this movement then causes topographic lows and valleys to form after all of the material in the ice sheet has been discharged.

The female figure was called Dynamic recrystallization (DRX) is a type of recrystallization process, found within the fields of metallurgy and geology.

In dynamic recrystallization, as opposed to static recrystallization, the nucleation and growth of new grains occurs during deformation rather than afterwards as part of a separate heat treatment.

Dynamic recrystallization allows for new grain sizes and orientation, which can prevent crack propagation.

After dynamic recrystallization, the ductility of the material increases.

In a stress–strain curve, the onset of dynamic recrystallization can be recognized by a distinct peak in the flow stress in [working] data, due to the softening effect of recrystallization.

If stress oscillations appear before reaching the steady state, then several recrystallization and grain growth cycles occur and the stress behavior is said to be of the cyclic or multiple peak type.

Geometric dynamic recrystallization.

Discontinuous dynamic recrystallization.

Continuous dynamic recrystallization.

Dynamic recrystallization is dependent on the rate of dislocation creation and movement.

It also determines the susceptibility of grains to various types of dynamic recrystallization.

Some authors have used the term 'postdynamic' or 'metadynamic' to describe recrystallization that occurs during the cooling phase of a hot-working process or between successive passes.

This emphasises the fact that the recrystallization is directly linked to the process in question, while acknowledging that there is no concurrent deformation.

Geometric dynamic recrystallization occurs in grains with local serrations.

While GDRX is primarily affected by the initial grain size and strain (geometry-dependent), other factors that occur during the hot working process complicate the development of predictive modeling (which tend to oversimplify the process) and can lead to incomplete recrystallization.