Adjective:

संघर्ष-संबंधी, घर्षण-संबंधी,

frictional's Usage Examples:

The general theory of this kind of brake is as follows: - Let F be the whole frictional resistance, r the common radius of the rubbing surfaces, W the force which holds the brake from turning and whose line of action is at a perpendicular distance R from the axis of the shaft, N the revolutions of the shaft per minute, co its angular velocity in radians per second; then, assuming that the adjustments are made so that the engine runs steadily at a uniform speed, and that the brake is held still, clear of the stops and without oscillation, by W, the torque T exerted by the engine is equal to the frictional torque Fr acting at the brake surfaces, and this is measured by the statical moment of the weight W about the axis of revolution; that is T =Fr=WR...

Soc., 1890, 48, 342) has demonstrated that it is quite unnecessary to assume either the directive force of Weber, the permanent set of Maxwell, or any kind of frictional resistance, the forces by which the molecular magnets are constrained being simply those due to their own mutual attractions and repulsions.

frictional force.

The terms due to F in (33) are such as would arise from frictional resistances proportional to the absolute velocities of the particles, or to mutual forces of resistance proportional to the relative velocities; they are therefore classed as frictional or dissipative forces.

The reason why the frictional resistance would be further increased is the very simple one that the increase in the rate of production implies directly a corresponding increase in the quantity of blast forced through, and hence in the velocity of the rising gases, because the chemical work of the blast furnace needs a certain quantity of blast for each ton of iron made.

There are some very evident disadvantages of excessive height; for instance, that the weight of an excessively high column of solid coke, ore and limestone tends to crush the coke and jam the charge in the lower and narrowing part of the furnace, and that the frictional resistance of a long column calls for a greater consumption of power for driving the blast up through it.

This inquiry yielded (in 1867) the result 783, and this Joule himself was inclined to regard as more accurate than his old determination by the frictional method; the latter, however, was repeated with every precaution, and again indicated 772.55 foot-pounds as the quantity of work that must be expended at sea-level in the latitude of Greenwich in order to raise the temperature of one pound of water, weighed in vacuo, from 60 to 61° F.

When work is done against these forces no full equivalent of potential energy may be produced; this applies especially to frictional forces, for if the motion of the system be reversed the forces will be also reversed and will still oppose the motion.

Motion is communicated to the rope by frictional contact with the drum,.

von Helmholtz, working on a similar hypothesis, but with a frictional term introduced into his equations, obtained formulae which are applicable to cases of absorption.