फेसप्लेट हिंदी उपयोग और उदाहरण

फेसप्लेट के समांतर तलों की सिधाई की परीक्षा भी इसके द्वारा की जाती है।

फेसप्लेट ढले लाहे का होता है, जिसका ऊपरी तल रंदा कर तथा बारीकी से सही स्क्रेप कर सम चौरस बना दिया जाता है।

"" गोनिये से कोण नापने में एक सहायक उपकरण, फेसप्लेट, की सहायता ली जाती है।

गोनिये से कोण नापने में एक सहायक उपकरण, फेसप्लेट, की सहायता ली जाती है।

मूल सिल्वर के बजाय काली फेसप्लेट।

सरफेस गेज फेसप्लेट पर रखकर पुर्जों के विभिन्न तलों की ऊँचाई नापने तथा फेसप्लेट से ही समांतर ऊँचाई प्रदर्शित करनेवाली रेखाएँ पुर्जों पर अंकित करने के काम आता है।

फेसप्लेट इसके अंग्रेजी अर्थ का उदाहरण

Powertool: A rational, construction-themed vigilante with a drill in his helmet's faceplate.

2008 – Matt Helders – Matt A lathe faceplate is a basic workholding accessory for a wood or metal turning lathe.

The workpiece is then clamped to the faceplate, typically using t-nuts in slots in the faceplate, or less commonly threaded holes in the faceplate itself.

The faceplate may be attached to the lathe in several ways: the two most common are a thread and a precision cone arrangement, and threaded studs and a circular recess fitting a flange on the end of the spindle.

Increasingly common is the camlock arrangement, in which shaped studs and cams replace threaded studs for rapid exchanging of the faceplate with other accessories, such as three or four jaw chucks.

The faceplate was the ancestor of lathe chucks, an arrangement of three or more adjustable 'dogs' bolted to the faceplate providing a primitive chuck arrangement.

It may seem that a faceplate is a primitive accessory superseded by precision chucks, but its inherent flexibility (almost any shape can be attached to a faceplate with care and the right fixings) and the possibility of achieving great accuracy by careful setup make it essential for a well equipped lathe.

For certain specialist jobs, temporary or special faceplates can be made, perhaps in wood or light alloy, that can be machined or adapted for difficult workholding jobs.

One example might be attaching thin sheet metal to a wooden faceplate using wood screws, allowing the trepanning of holes, with the tool cutting into the sacrificial faceplate material.

The faceplate of the digital line card is equipped with a red LED that lights when the card is disabled.

The four most commonly used workholding devices are the three-jaw chuck, the four-jaw chuck, the collet, and the faceplate.

The rewind release was moved from the front right faceplate to the top of the camera between the ASA setting dial and the advance lever arm.

The Droid Razr featured Kevlar backing, the same used in bulletproof vests, and a Gorilla Glass faceplate.