पोतभित्ति इसके अंग्रेजी अर्थ का उदाहरण

Stressed ducts in s-shape are locked with airframe with the loaded bulkheads which are made of composite materials spanning the aircraft from air intake to engine shafts.

These areas were separated by two transverse watertight bulkheads, the collision bulkhead at frame 12, and the engine room forward bulkhead at frame 173.

Some planes had one or more bulkhead mounted phone stations with cordless handsets that the passengers could use, instead of the multiple wired handsets.

The bulkhead was situated about inboard from the side of the ship.

Dee Why and Curl Curl had double-ended steel hulls with a bar keel, 6 watertight bulkheads and timber decks.

At the aft end of the steering gear compartment would have been a transverse bulkhead.

First, the bulkhead windows were rounded as compared to being squared, and like the 1000-series before rehabilitation, these cars did not have exterior speakers.

Fuselage of semi-monocoque construction employing longerons and bulkheads, with an ovoid cross-section.

In 1909, the first "seawall", a wooden bulkhead that protected part of the island, was built.

Designed and built by Green Marine, each boat is constructed of over 100"nbsp;mm thick fibre reinforced composite topsides, single laminate double hull bottoms, 4 water-tight bulkheads and prepreg epoxy, glass and Kevlar shields.

Deutschland's underwater protection consisted of a thick torpedo bulkhead; Admiral Scheer's and Admiral Graf Spee's bulkheads were reduced to .

The ends of the central armored citadel were enclosed by transverse bulkheads thick.

The jacks were connected to a Jackall Pump on the bulkhead that enabled the front, the back, or the entire car to be raised to facilitate a wheel change.

पोतभित्ति इसके अंग्रेजी अर्थ का उदाहरण

This has the added advantage of being able to cool the entire vessel wall with feedwater, but results in a complex and materially demanding (high temperature, high temperature differences, high radiation) internal calandria and plena arrangement.

Magnetic resonance angiography is used to generate images of arteries (and less commonly veins) in order to evaluate them for stenosis (abnormal narrowing), occlusions, aneurysms (vessel wall dilatations, at risk of rupture) or other abnormalities.

Saturation artifact due to laminar flow: In many vessels, blood flow is slower near the vessel walls than near the center of the vessel.

This causes blood near the vessel walls to become saturated and can reduce the apparent caliber of the vessel.

Reactor pressure vessel wall: a massive steel shell encases the whole fuel assembly and primary coolant hermetically.

Where viscous products are handled, anchor shaped paddles are often used which have a close clearance between the blade and the vessel walls.

An increase in shear stress causes an increase in the number of monocyte chemoattractant protein-1 (MCP-1) molecules expressed on the surface of vessel walls as well as increased levels of TNF-α, bFGF, and MMP.

Monocytes can enter the vessel wall to become macrophages and produce inflammatory cytokines such as TNF-α in addition to aiding the production of bFGF and MMP (Van Royen et al.

Thickness of rector vessel walls: 5½"nbsp;inches.

The infiltrate is predominantly perivascular with endothelial-cell swelling in some vessels, but vasculitic changes (blood clots; deposition of fibrin, complement, or immunoglobulins within the vessel walls; red blood cell extravasation;inflammatory infiltration of vascular walls) are absent in early lesions.

CD38 on leukocytes attaching to CD16 on endothelial cells allows for leukocyte binding to blood vessel walls, and the passage of leukocytes through blood vessel walls.