पिस्टन-रॉड इसके अंग्रेजी अर्थ का उदाहरण

The Citroën SM-derived power steering is not power "assisted", but rather full power with no mechanical connection between the steering wheel shaft and the steering linkage yoke attached to the power piston rod.

Due to the effective cross sectional area reduced by the area of the piston rod, the instroke force is less than the outstroke force when both are powered pneumatically and by same supply of compressed gas.

Stroke length for this design is not limited, however, the piston rod is more vulnerable to buckling and bending.

In a swashplate engine the piston rods stay parallel with the shaft, and piston side-forces that cause excessive wear can be eliminated almost completely.

Upon actuation, the piston rod and each succeeding stage "telescopes" out as a segmented piston.

The telescoping cylinder incorporates a piston rod nested within a series of hollow stages of increasing diameter.

The piston rod is typically a hard chrome-plated piece of cold-rolled steel that attaches to the piston and extends from the cylinder through the rod-end head.

The piston rod is highly ground and polished so as to provide a reliable seal and prevent leakage.

The barrel is closed on one end by the cylinder bottom (also called the cap) and the other end by the cylinder head (also called the gland) where the piston rod comes out of the cylinder.

In that case the piston rod is also used as a piston barrel and a second piston rod is used.

The piston is a disc or cylinder, and the piston rod transfers the force it develops to the object to be moved.

Being thus enclosed in the cylinders, they are worked with piston rods and levers.

If we assume that the oil enters from the cap end, during extension stroke, and the oil pressure in the rod end/head end is approximately zero, the force F on the piston rod equals the pressure P in the cylinder times the piston area A:.

पिस्टन-रॉड हिंदी उपयोग और उदाहरण

एक इंजन में, इसका उद्देश्य होता है सिलेंडर में विस्तारित होती गैस के बल को एक पिस्टन रॉड और/या कनेक्टिंग रॉड के माध्यम से क्रैंकशाफ्ट में स्थानांतरित करना. पंप में, इस कार्य का उलटा होता है और बल को सिलेंडर में द्रव को संपीड़ित करने या बाहर करने के उद्देश्य से क्रैंकशाफ्ट से सिलेंडर में स्थानांतरित किया जाता है।

"" एक इंजन में, इसका उद्देश्य होता है सिलेंडर में विस्तारित होती गैस के बल को एक पिस्टन रॉड और/या कनेक्टिंग रॉड के माध्यम से क्रैंकशाफ्ट में स्थानांतरित करना. पंप में, इस कार्य का उलटा होता है और बल को सिलेंडर में द्रव को संपीड़ित करने या बाहर करने के उद्देश्य से क्रैंकशाफ्ट से सिलेंडर में स्थानांतरित किया जाता है।