निकास वाल्व Meaning in English
निकास वाल्व शब्द का अंग्रेजी अर्थ : exhaust valve
ऐसे ही कुछ और शब्द
थकानेवाला कामथकाऊपन
एग्सेस्टिव
एग्सेस्ट्स
एक्ज़िबिट
प्रदर्शित करना
नुमाइश
प्रदर्शनी
प्रदर्शनी देखना
प्रदर्शनी लगाने का स्थान
प्रदर्शनी का हाल
प्रदर्शनी के लिये कमरा
प्रदर्शनवाद
प्रदर्शनीयता
प्रदर्शनीवादी
निकास-वाल्व हिंदी उपयोग और उदाहरण
"" वास्तविक इंजन में ईधन-वायु-मिश्रण को घटाने बढ़ानेवाले यंत्र से, जिसे प्ररोध (थ्रटल) कहते हैं, तथा अंतर्ग्रहण और निकास वाल्वों से मिश्रण की गति में कुछ बाधा पड़ती है।
""निकास वाल्व का कुछ शीघ्र खुल जाना, जिससे पिस्टन पर उल्टा दाब नहीं पड़ता और ऋणात्मक कार्य नहीं करना पड़ता;।
वास्तविक इंजन में ईधन-वायु-मिश्रण को घटाने बढ़ानेवाले यंत्र से, जिसे प्ररोध (थ्रटल) कहते हैं, तथा अंतर्ग्रहण और निकास वाल्वों से मिश्रण की गति में कुछ बाधा पड़ती है।
निकास वाल्व का कुछ देर में बंद होना, जिसके कारण जली गैसों को बाहर निकलने के लिए पर्याप्त समय मिल जाता है और वे अपने ही जडत्व से सिलिंडर से लगभग पूर्णत: निकल जाती हैं;।
निकास वाल्व का कुछ शीघ्र खुल जाना, जिससे पिस्टन पर उल्टा दाब नहीं पड़ता और ऋणात्मक कार्य नहीं करना पड़ता;।
(4) 'निकास'(Exhaust Stroke) - अब निकास वाल्व खुल जाता है और आरोही पिस्टन जली हुई गैसों को सिलिंडर के बाहर निकाल देता है।
निकास-वाल्व इसके अंग्रेजी अर्थ का उदाहरण
The 6-cylinder, inlet over exhaust valve, 2103 cc Rover engine was slightly modified with higher compression ratio to raise the output by to whilst the 100 version was bored out to 2392"nbsp;cc and fitted with triple SU carburettors to give .
Anti-lag systems work in one of two ways: by running very rich AFR and pumping air into the exhaust to ignite the extra fuel in the exhaust manifold; or by severely retarding ignition timing to cause the combustion event to continue well after the exhaust valve has opened.
| Experimentally fitted with Owen's double port exhaust valves from new and renumbered immediately after entering service.
Pumping mean effective pressure (PMEP) - Mean effective pressure from work moving air in and out of the cylinder, across the intake and exhaust valves.
The gasses exit the cylinder through an exhaust valve at the top of the cylinder.
At the end of this phase, the exhaust valve closes and the intake valve opens, which then closes to allow a fresh air/fuel mixture into the cylinder so the process can repeat itself.
As the rocker arms are critical to having the intake and exhaust valves operate, it was necessary to keep them constantly oiled.
2 piece, blade style, exhaust valves which have two positions - open and closed.
3 piece, blade style, exhaust valves with three positions - closed, half open and fully open.
However, the initial VJ22 models had a design flaw in the 'improved' 3 piece exhaust valves in which they crack likely due to carbon build up from boiling oil within the mechanism and failed to open from the idle/low power position.
24v's engine include a new, lighter crankshaft, new exhaust valves (sodium filled for improved heat dissipation), new combustion chambers, new lighter connecting rods, new lighter forged aluminium pistons, and new IHI turbochargers.
The intake valves were operated by the suction caused by the intake stroke, while the exhaust valves were operated by an eccentric brass ring on the rear wheel and a device at the cylinder head that opened each cylinder's valve alternately.
When an engine exhaust valve is open, the pressure in the exhaust manifold is higher than atmospheric pressure.
Designed to give reliable service under prolonged hard use, the engine featured deep water jackets, an innovative diagonal head-to-block joint that allowed for oversized intake and exhaust valves, thermostatically controlled oil cooling, copper-lead bearings, and a hardened crankshaft.