टेलप्लेन हिंदी उपयोग और उदाहरण

इस प्लानफार्म का उपयोग नियंत्रण सतह जरूरतों को कम से कम रखता है (कोई टेलप्लेन या फोरप्लेन नहीं, केवल एक ऊर्ध्वाधर टेलफिन), व्यापक श्रेणी के बाहरी स्टोर के वहन की इजाजत देता है और क्रुसीफार्म संरचना की तुलना में बेहतर करीबी मुकाबला करने, उच्च गति और उच्च अल्फा भूमिकाओं की विशेषता वाला होता है।

"" इस प्लानफार्म का उपयोग नियंत्रण सतह जरूरतों को कम से कम रखता है (कोई टेलप्लेन या फोरप्लेन नहीं, केवल एक ऊर्ध्वाधर टेलफिन), व्यापक श्रेणी के बाहरी स्टोर के वहन की इजाजत देता है और क्रुसीफार्म संरचना की तुलना में बेहतर करीबी मुकाबला करने, उच्च गति और उच्च अल्फा भूमिकाओं की विशेषता वाला होता है।

टेलप्लेन इसके अंग्रेजी अर्थ का उदाहरण

The fuselage is slightly different, with a slight sweep-back of the wings and the tailplane is larger.

A total of 50 of the early-production Mk IIs were modified into trainers as the Mark III, by adding dual controls and instruments for the student pilot and an externally braced tailplane.

It was created by connecting two Hotspur fuselages together, using a constant-chord centre wing section of length, and a constant-chord tailplane.

Production series, dual controls and instruments, external tailplane bracing.

Two standard Hotspur fuselages and outer wing panels joined together with common centre section and tailplane; single prototype made.

The fabric-covered fuselage carried an unbraced tailplane, without elevators but with turned-up tips.

The port side of the tailplane had an inverted aerofoil section to counter roll-axis torque produced by the propeller.

As with most autogyros, a high vertical tail was precluded by the sagging resting rotor, so the dorsal fin was long and low, extending well aft of the tailplane like a fixed rudder and augmented by a ventral fin.

There was additional bracing to the tailplane and both it and the fin carried small movable trimming surfaces.

In these designs, the tailplane (horizontal stabilizer) is typically high-mounted on twin tail fins to keep it clear of the engine wake.

However the twin booms and bridging tailplane still obstruct the field of view to some extent and guns in this position are especially restricted in firing to the side.

On the other hand tip effects on the tailplane are avoided and it is supported at both ends, allowing it to be made smaller and lighter.