एलॉयिंग इसके अंग्रेजी अर्थ का उदाहरण

Since no arc or combustion is used, the temperature of the material is no higher than required to melt it; this can prevent loss of valuable alloying elements.

The one major drawback to induction furnace usage in a foundry is the lack of refining capacity; charge materials must be clean of oxidation products and of a known composition and some alloying elements may be lost due to oxidation (and must be re-added to the melt).

The corrosion-retarding effect of the protective layer is produced by the particular distribution and concentration of alloying elements in it.

Synthesis of chromium carbide can be achieved through mechanical alloying.

After undergoing any ladle treatments, such as alloying and degassing, and arriving at the correct temperature, the ladle is transported to the top of the casting machine.

Avoiding turnarounds requires the meltshop, including ladle furnaces (if any) to keep tight control on the temperature of the metal, which can vary dramatically with alloying additions, slag cover and deslagging, and the preheating of the ladle before it accepts metal, among other parameters.

Notably, certain artifacts from West Mexico contain tin or arsenic at concentrations as high as 23 weight percent, while concentrations of alloying elements at roughly 2 to 5 weight percent are typically adequate for augmented strength and mechanical utility.

Alloyed with gallium arsenide it forms indium gallium arsenide - a material with band gap dependent on In/Ga ratio, a method principally similar to alloying indium nitride with gallium nitride to yield indium gallium nitride.

The following table lists the principal alloying element for four of the more common types used in modern industry, along with the name for each type.

Fellows of the Society of Antiquaries of London Selective leaching, also called dealloying, demetalification, parting and selective corrosion, is a corrosion type in some solid solution alloys, when in suitable conditions a component of the alloys is preferentially leached from the material.

The effect can be substantially reduced by alloying the cast iron with nickel.

15 mV/°C, and corrosion problems caused by the platinum wires alloying with the zinc amalgam connections where they enter the glass envelope.

By alloying the material, impurity atoms in low concentrations will occupy a lattice position directly below a dislocation, such as directly below an extra half plane defect.